Many dentists struggle with how to fabricate a crown for a tooth that is an abutment for an existing removable partial denture, especially because the removable partial dentures are rarely submitted with the case. This article conveys the questions that are often asked on how to approach this problem and even some of the unreasonable requests doctors face.

Here were some conclusions to concerns:

  • Often an impression of the prepared tooth without any indication of how the rpd seats on the abutment is sent to the lab so it’s a total guess job where the clasp and rests should go.  (I’m not making this up.)
  • There is often insufficient tooth reduction and consequently insufficient restorative space for the final materials and the rpd clasping.
  • Lastly, and most frustrating, the rpd is requested back the same day. Really!(Of course with CEREC technology in your office, this problem won’t exist as you can scan the tooth before prepping and mill the crown right to it.)

A GC Pattern or duralay pattern resin is fabricated over the prep with the RPD seated into it and it forms a coping that the lab can use as an index recording of where the rest seat and clasps should be. (See Figure 1)

fabricating a crown to an existing removable partial denture figure 1

 

1. Prepare the tooth and make an impression with your desired impression material. Make sure you have plenty of prep clearance around the clasps and rest seat. Then seat the rpd and express some bite registration material (medium to light body is probably easier than something hard and rigid for trimming purposes).

fabricating a crown figure 2

fabricating a crown figure 3

2. Be sure to cover the clasps and rest seats. Once set, remove the rpd and the registration and carefully start trimming back the material until you expose the outer surfaces of the clasps and rests and any material that will prevent you from releasing the rpd.

fabricating a crown figure 4

3. Push the index out of the partial by gently pushing on it apically. You will be able to see some of the preparation of your tooth in this registration and you want this so that the lab can index it on the die (from the first impression you made). Be sure to put it in a box when sending it to your lab to protect it during shipping.

4. Once at the lab, the bite registration will be fitted on the die and pattern resin will be flowed into the grooves of the clasps and rests. It also will need to extend down onto the model where the minor connector portion of the rpd would be.

fabricating a denture figure 5

5. Once this has set, cut away the registration material and utilize the resin clasp assembly to construct the contours of the crown.

fabricating a crown figure 6

fabricating a crown figure 7

This works really nicely and is the most predictable way laboratories have found to retrofit a crown to an existing RPD without taking the RPD from the patient

Have a conversation with your technician and establish that this would be an ideal way to approach this clinical problem.

Although it is an additional step for you and the lab, this clinical scenario is easily constructed with a high level of certainty and success.